Parts / Controller box base, version B (battery)
Drag to orbit · pinch / scroll to zoom · two fingers / right-drag to pan. Shown as exported for printing, on a 10 mm grid.
Controller box base, version B (battery) primary
Adds the 2000 mAh LiPo bay under the perfboard and the Adafruit 6106 charger/boost board (its USB-C is the box USB-C).
- File
hardware/stl/ebox_B_battery_base.stl- Bounding box
- 57.59 × 47.59 × 21.70 mm (X × Y × Z, as exported; Z up from the bed)
- Volume
- 11.92 cm³; ≈ 15.1 g if printed solid in PETG (real mass depends on walls and infill)
- Mesh
- 12,032 triangles
- Material
- PETG
- Layer
- 0.2 mm
- Walls / infill
- 3 walls, 15 %
- Orientation
- Base bottom down.
- Supports / brim
- None.
- Quantity
- 1 per 2 heads
- Versions
- B
Print settings are starting points from ASSEMBLY.md and the print plan, not values tested on this design. Dimensions that depend on the knob, rod or clip are estimated from photo, not caliper.
← Controller box lid, version AController box lid, version B →