Combined pane pack, version D (panel + low-temperature cell) primary

One flat part between the panes: the panel pocket (4.1 mm) and, beside it, a pocket for a 5.3 mm low-temperature LiPo pouch (6.6 mm overall) with a channel for the NTC and the pad wires. Rounded, continuous skin. The cell grade, the charge window and the summer heat are estimates; see docs/power-solar.md Part D.

Download STL (333 KB, binary)

File

hardware/stl/pane_pack_combined_D.stl

Bounding box

139.40 × 117.80 × 6.60 mm (X × Y × Z, as exported; Z up from the bed)

Volume

14.56 cm³; ≈ 15.6 g if printed solid in ASA (real mass depends on walls and infill)

Mesh

6,808 triangles

Material

ASA, white (the white skin is the cell's sun shield)

Layer

0.2 mm

Walls / infill

3 walls, 100 %

Orientation

As exported: back (cell cover side) down, panel pocket up.

Supports / brim

None (the cell pocket opens to the bed).

Quantity

1 per controller box

Versions

D

See it in the assembly →

Print settings are starting points from ASSEMBLY.md and the print plan, not values tested on this design. Dimensions that depend on the knob, rod or clip are estimated from photo, not caliper.