Parts / Combined pane pack cell cover (D)
OpenSCAD render of Combined pane pack cell cover (D)
Drag to orbit · pinch / scroll to zoom · two fingers / right-drag to pan. Shown as exported for printing, on a 10 mm grid.
Combined pane pack cell cover (D) primary
0.6 mm cover that drops into the rebate over the cell pocket; held by the pane pressure / tape, no glue on the window.
- File
hardware/stl/pane_pack_combined_D_cover.stl- Bounding box
- 51.20 × 116.20 × 0.60 mm (X × Y × Z, as exported; Z up from the bed)
- Volume
- 3.56 cm³; ≈ 3.8 g if printed solid in ASA (real mass depends on walls and infill)
- Mesh
- 2,716 triangles
- Material
- ASA, white
- Layer
- 0.2 mm
- Walls / infill
- 100 %
- Orientation
- Flat as exported.
- Supports / brim
- None.
- Quantity
- 1 per pack
- Versions
- D
Print settings are starting points from ASSEMBLY.md and the print plan, not values tested on this design. Dimensions that depend on the knob, rod or clip are estimated from photo, not caliper.
← Combined pane pack, version D (panel + low-temperature cell)Combined pane pack, north-window option (D) →